BRICK TILE™
Available in a variety of colours and patterns. Tiles supplied in standard, half and corner formats.

Ivanhoe Cream |

Ivanhoe Burnt Red |

Ivanhoe Rural Blend |

Bradgate Red |
Choose from 10 bonding patterns

Horizontal Stackbond
60 stretchers |

Stretcher Bond
60 stretchers |

Flemish Bond
80 total per m²
(40
headers & 40 stretchers) |

Monk
Bond
72 total per m²
(48 stretchers & 24 headers) |

Double Herringbone
60 stretchers |

English Bond
90 total per m²
(30
stretchers & 60 headers) |

English Garden Wall
68 total per m²
(50
stretchers & 18 headers)
OR
73 total per m²
(46
stretchers & 27 headers)
depending on the bond used |

Vertical Stackbond
60 stretchers |

Basket Weave
60 stretchers |

Single Herringbone
60
stretchers |
FITTING INSTRUCTIONS
Surface preparation
- Remove any loose paintwork, and repair any flaking surfaces.
- Dust down the prepared surface and remove any grease or dirt.
- Dampen absorbent surfaces with a water spray, or damp brush.
Adhesive
- Mix your heavy duty tile adhesive, Such as Ceresit CM18 or Ardex X7GPlus to the desired consistency
- Apply the adhesive to the surface
at a depth of 3-4mm to an area you can cover quickly (5-10 tile
area.)
Fitting the brick tiles
- From the bottom upwards, adhere your brick slips to the desired surface, cutting in where necessary.
- Adhere your second course, using your desired bond pattern and using 10mm spacers between courses.
- Complete the works whilst the adhesive is still workable.
Pointing
- Once the adhesive is cured point the brick slips using sand cement mortar, or a gun-able mortar such as Easipoint.
- Once mortar is touch dry complete desired pointing effect with a steel pointing tool or similar finishing equipment.
If you have any queries please contact our technical department: 0141 552 7766
Download Installation Guide
|